First Server Run

If you run ultravnc server for the first time, the settings "ultravnc.ini file" does not exist and firewall need to allow winvnc.

When no password has been set, ultravnc prompt you to set one.

When you are running on XP and winvnc was installed as service you first get the "runas"
box, DON'T FORGET TO UNCHECK else you tell runas that winvnc can't make changes to
a file.

First connection (loopback)

Now that the server is running, we can make a fast test connection in loopbackmode.(loopback mode= server+ viewer on same PC)

1* Tell server to allow loopback

2* Tell viewer to connect to the server

Start the viewer vncviewer.exe

When all is ok you should see the viewer showing himself like watching 2 mirrors( not usufull to do anything, but it tell server and viewer can connect)

First connection (local network)

Install viewer  on second PC ( the pc you gonna use the control the server)

* Use the installer and select viewer only.
* Or, copy vncviewer.exe on a usb stick and plug this in your viewer PC.
* Or, use a shared/mapped folder and copy.

The server ip address can be found by hovering the mouse over the vnc server tray icon.

Instead of "localhost" you need to enter this ip address